Code: Select all
RF remote control functions are:
+--------+--------+--------+
| ON | Toggle | OFF |
+--------+--------+--------+
|BRI_ALL |BRI_RGB | BRI_ W |
+--------+--------+--------+
| DIM_ALL| DIM_RGB| DIM_W |
+--------+--------+--------+
| RED | GREEN | BLUE |
+--------+--------+--------+
| ORANGE | LT GRN | LT BLUE|
+--------+--------+--------+
| AMBER | CYAN | PURPLE |
+--------+--------+--------+
| YELLOW | PINK | WHITE |
+--------+--------+--------+
this is done automatically with the first received RF code.
if later it is necessary to reactivate the pairing:
access WiFiConfig by pressing the button for at least 10 seconds.
in the "suppla server" field write "get_new_rf" and press Save.
WiFiConfig data does not change, the LC10 reboots and RF pairing is activated again.
you have to write "get_new_rf" as shown below, without blank spaces.
Code: Select all
get_new_rf
the button "Gpio0 to GND" has the following functions:
click = TOGGLE_RGB.
doubleClick = TOGGLE_W.
10 seconds = WiFiConfig.