Using SUPLA with my own created Hardware

scropion86 · Post Mon May 30, 2016 8:51 am

Hi

i have interest to use SUPLA with my OWN hardware , i build it and already used it and Running for more that month.
mainly is use BLYNK http://www.blynk.cc/ , or MQTT based control.
here is the my board http://egyiot.xyz/pcb-design/egyiot-esp ... iot-board/

Relay 1 - GPIO4
Relay 2 - GPIO13
Relay 3 - GPIO16

LED RGB

RED - GPIO14
Green - GPIO12
Blue - GPIO5

Please guide me how to write the sketch that will work with my board.

pzygmunt · Post Mon May 30, 2016 9:17 am

Hi. Which functions you need ?

scropion86 · Post Mon May 30, 2016 9:48 am

3 Relays on/Off and 1 RGB color selector

pzygmunt · Post Mon May 30, 2016 10:47 am

I will prepare dedicated firmware for you. Do you have some name for your board ?
Which GPIO I can use as cfg button ?

scropion86 · Post Mon May 30, 2016 11:26 am

thank you so much , My Board called EgyIOT , and i didn't set an Config button , i just have the RESERT and GPIO2 to pulled up with button to boot in Boatloader mode , but i think it can be used as config button after board started .

send me the FW and i will test it , also do you have any tutorial to write my own FW in Arduino IDE or Platformio

scropion86 · Post Mon May 30, 2016 11:29 am

do you have a Libaray that can be used in Arduino IDE , API documentation to your Cloud , Restfull API ?

pzygmunt · Post Tue May 31, 2016 10:21 am

Arduino - you can use this: https://github.com/SUPLA/arduino but is not dedicated for support Arduino+ESP8266
API - at this moment API is not avaiable. I plan provide it in the future

You can test now dedicated firmware that I build for you. RGB is not yet implemented. I need more time.

Binary: https://github.com/SUPLA/ESP8266/tree/master/EgyIOT
Sources: https://github.com/SUPLA/supla-core/tre ... SP8266_IOT

scropion86 · Post Tue May 31, 2016 10:34 am

thanks for your effort , i will test it an let you know.

scropion86 · Post Tue May 31, 2016 4:24 pm

HI

very sorry for my mistake ,
the GPIO2 is puled UP by default and the button is connected to GPIO0 to pull it Down.
the device should go to Config. mode if GPIO0 is Low for 5 second.

because of that the FW didn't work and never go to Config mode.

here is part of my schematic.

Untitled picture.png

scropion86 · Post Tue May 31, 2016 4:52 pm

after flashing the FW , i connected GND to GpIO2 for more than 5 second and still not able to go in Config. mode