Page 3 of 6
Re: SONOFF
Posted: Mon May 14, 2018 12:14 pm
by gaurav
Can anybody tell me?
Re: SONOFF
Posted: Mon May 14, 2018 12:25 pm
by pzygmunt
GPIO 15 should be pulled down to the GND.
You should properly set/init this port on boot.
Re: SONOFF
Posted: Tue May 15, 2018 10:03 am
by gaurav
I've connected GPIO15 to GND via 10K resistor.
Problem is same.
Re: SONOFF
Posted: Tue May 15, 2018 10:08 am
by pzygmunt
"You should properly set/init this port on boot."
Re: SONOFF
Posted: Mon May 28, 2018 1:26 pm
by gaurav
I am trying to flash Sonoff Socket firmware in Sonoff Basic R2 module. Flashing shows success but there is no ssid broadcast no led blinking and garbage values on putty Baudrate used on putty 74880 and 115200.
config
boot file address 0x00000
sonoff socket firmware 0x01000
esp_int 0xFC000
flash size 1 MB
baud rate 115200
SPI speed 40MHz
SPI Mode DOUT
USB to TTL device used "PL2303" and "arduino uno as USB to TTL".
Tools used to flash "Nodemcu firmware programmer" and "ESP flash download tool". What could be the problem? Am I missing anything?
Re: SONOFF
Posted: Tue May 29, 2018 8:59 am
by gaurav
Can anyone help me. I am pressing the GPIO 0 button before powering up the Sonoff Basic R2 to enter it into flash mode. Never had this problem earlier.
Re: SONOFF
Posted: Tue May 29, 2018 12:45 pm
by pzygmunt
Connect Putty.
Turn on the device and check logs.
Re: SONOFF
Posted: Tue May 29, 2018 1:23 pm
by gaurav
I connected to putty with two baudrates 74880 and 115200.
Re: SONOFF
Posted: Tue May 29, 2018 1:29 pm
by pzygmunt
Connect USB GND with GND on BOARD
Re: SONOFF
Posted: Tue May 29, 2018 1:31 pm
by gaurav
usb gnd is connected to the board.