Supla Button 4 direct links

[Kaowiec]

Great idea and great job!
Thank you!

Is it possible to use bistable instead of monostable buttons. If so - can I ask for compilations.
And the second question. Can I use http links instead of https? I use everything in the local network so I do not need https.

The perfect version for me: links 60 characters, http and bistable buttons

[elmaya]

4 direct links for battery use

4 direct links button: L1-L4
wificonfig button: config
connect EN to VCC to allow programming
the process is slow (5 or 6 seconds) due to connection to wifi
virtually no standby consumption using chip-enable
add resistor 220k Ohm to suspend Flash in standby mode



Initial parameters for "ESP Falsh Download Tool":

CreystalFreq 26M
SPI SPEED 40 MHz
SPI MODE QIO
BAUDRATE 11520
FLASH SIZE 32Mbit (4MByte)

D_Link_LowPower_x4.bin ------------> 0x00000

[elmaya]

direct link X6 for bistable switch
using toggle action will send link when swish state changes
useful to change state on any device
so it is able to switch 6 devices

Link 1 - D1
Link 2 - D2
Link 3 - D3
Link 4 - D5
Link 5 - D6
Link 6 - D7
wifi config - D0
satus Led - D4

Initial parameters for "ESP Falsh Download Tool":

CreystalFreq 26M
SPI SPEED 40 MHz
SPI MODE QIO
BAUDRATE 11520
FLASH SIZE 32Mbit (4MByte)

D_Link_bistable_x6.bin ------------> 0x00000

[Kaowiec]

Something is wrong.
My wemoss is permanently in AP mode.
After upload firmware (ver. bistable) I'm filling WiFi, links and credentials as always.
Credentials are saving corectly (putty say so) and... wemoss is going back to AP mode.

[elmaya]

erase flash before you upload firmware
don't forget pull up resistor on - D0 - 4,7kohm

[Kaowiec]

erase flash before you upload firmware
don't forget pull up resistor on - D0 - 4,7kohm

I have 5.1 resistor. And it was erased allready.

[elmaya]

try to connect to another WiFi
or just leave "SSID" and "password" empty

Do you see "config saved" on terminal before its reset and restart config portal?
or connection result 0?

[Kaowiec]

Electronics teaches humility ...
After a "hundreds of unsuccessful attempts", it finally succeeded.
It seems that my Wemoss only likes the DOUT mode.
In addition, everything must be uploaded in the appropriate sequence (long story...)
Now tests in the wall

[elmaya]

Maybe with this logo?



if not could you indicate which?

[maffiu]

would it be possible to connect a PIR sensor?